Search results

  1. RipperF350

    seems like it is losing coolant

    yup just had to do headgaskets on my 05
  2. RipperF350

    HELLP 2005 6.0 Stumbled onto its face and died last night

    it was sudden and the loss of power was very fast it went from normal running condition to dead in about 3 minutes missing worse and worse until it finally died Ford had it for 7 days 5 working days
  3. RipperF350

    HELLP 2005 6.0 Stumbled onto its face and died last night

    It was the HPOP replaced under warranty
  4. RipperF350

    2005 6.0 stumbled on its face and died

    I was thinking it was the FICM too it pops the FICM relay every now and then I'm guessing there is a short somewhere either way i got it to the dealer so its there problem now i'll let everyone know what Ford figures out
  5. RipperF350

    Sluggish shifting & Turbo lag

    4 inch exaust will lower your EGT and deffinatly sound good. As for the turbo lag only way to help that is to chip it or get a tunner
  6. RipperF350

    HELLP 2005 6.0 Stumbled onto its face and died last night

    got fuel... at first i though it ran out of fuel so I did them the other day right after it died on me they only had about 12,000 on them fuel was in the fuel filter above the motor when i replaced it. We also checked fuel pressure last night and did diagnostic check with the Solist for the...
  7. RipperF350

    HELLP 2005 6.0 Stumbled onto its face and died last night

    Thanks Thanks for the information, now all I have to do is take out the chip and the exhaust so i don't get the run around at the dealer. Anyone know of any good dealers in my area (GILROY, CA). I wont go back to the Morgan Hill Ford Store ever again they messed up more than they fixed when...
  8. RipperF350

    2005 6.0 stumbled on its face and died

    I don't think its the HPOP any more ok so my buddy brought over his scanner last night and the HPOP was at 580 PSI when cranking even with the batteries running a little low. We did come up with 11 codes P0269 Cyl. 3 Contribution Balance Fault P2290 ICP to low P2291 ICP to low cranking...
  9. RipperF350

    HELLP 2005 6.0 Stumbled onto its face and died last night

    Not the HPOP ok so my buddy brought over his scanner last night and the HPOP was at 580 PSI when cranking even with the batteries running a little low. We did come up with 11 codes P0269 Cyl. 3 Contribution Balance Fault P2290 ICP to low P2291 ICP to low cranking and P0261-P0282...
  10. RipperF350

    2005 6.0 stumbled on its face and died

    no smoke at least none that i noticed been going though some threads may be the HPOP but it started out bad and got progressively worse almost like I drove it into the ground in a matter of minutes. Seems like when the HPOP goes it just dies
  11. RipperF350

    2005 6.0 stumbled on its face and died

    So I want to try and diagnose this myself before I end up having to take off all my mods and take it back to the dealer so if anyone could help that would be greatly appreciated. Last night I was getting onto the freeway and the truck just didn't seem to have all the power it normally does...
  12. RipperF350

    HELLP 2005 6.0 Stumbled onto its face and died last night

    the engine light never came on I have to wait until Tuesday to check codes my buddie is going to bring his code reader over but his shop is closed for the holiday If it was HPOP would my oil pressure drop I was watching all gauges closely and all had normaly readings. Is there a way to...
  13. RipperF350

    HELLP 2005 6.0 Stumbled onto its face and died last night

    So I want to try and diagnose this myself before I end up having to take off all my mods and take it back to the dealer so if anyone could help that would be greatly appreciated. Last night I was getting onto the freeway and the truck just didn't seem to have all the power it normally does...
  14. RipperF350

    HELP Crazy sound like someone is hitting my truck with a Hammer

    It was Morgan Hill Ford Store that caused it. I checked my body mounts, the driver side front the one under your feet was at 25lbs the middle one was at 30lbs I tightened both of these to 90lbs because the rest were at 110lbs and the service manual says to put them at 60 lbs. Took her for a test...
  15. RipperF350

    HELP Crazy sound like someone is hitting my truck with a Hammer

    sway bar ? I checked the sway bar end links and the ball joints tonight I checked everything once again with the full weight of the truck and then jacked up the frame and checked everything with the suspension free floating. The sway bar bushings and end links all looked in good condition and...
  16. RipperF350

    HELP Crazy sound like someone is hitting my truck with a Hammer

    checked and checked again I've checked them a few times and nothing i even got out my torque wrench and checked everything over I did notice a gap on one of my upper ball joint on the top of the knuckle on the driver side the passenger side has a gap as well but its half the size I'm taking it...
  17. RipperF350

    HELP Crazy sound like someone is hitting my truck with a Hammer

    Ok so I lifted my truck about 4 months ago and it made this noise every once in a great while, this was with the stock tires. On Monday I had 4 Wheel Parts put some 35" FC II's on her and do the alignment. Now almost every time I make a turn and there is some small or large bump I hear a bang...
  18. RipperF350

    Tire Question please help

    so now what thanks for the info Pro Comp recommends 35x 12.5 tires but there is no way i can get those to fit on duallys even with new rims but dose anyone know where i can get some wider after market dually rims as cheap as possible or some other way to get closer to 35" tires I havent...
  19. RipperF350

    Tire Question please help

    Anyone, I have a 2005 4x4 dually F-350 with 17x6 inch rims. I just bought a 5 inch Explorer Pro Comp lift kit for get this $300 what a steal but anyways I want to put bigger tires on but i don't want to get new rims if i can get around it. I really want to use 315/70 R17 but all the tire...
  20. RipperF350

    lifting my dually 4inch or 6inch any one know tires sizes

    4 inches 35's 8mpg wow 4 inches with 35's seems like the way to go i can't believe she is getting 8 mpg with a lift like that, dose she drive with a cement foot or something? I'm hoping that my mods will help with that I'm pretty good about keeping my foot out of it most of the time i average...
  21. RipperF350

    lifting my dually 4inch or 6inch any one know tires sizes

    I really want to lift my truck soon but i'm undecided on what lift to use. Dose anyone know the max. tire size i can put on a 4inch lift and a 6 inch lift on a dually? Dose anyone have any suggestions? I don't want to get to crazy because i do tow a little, the only reason i want to lift it is...
  22. RipperF350

    Tuners? Do They Void Warranty

    Hey guys I was just wondering if anyone out ther has had a problem with the dealer not doing warranty work because of a tuner or chip installed on the truck I heard that Banks will back you up is this true

Members online

Total: 193 (members: 2, guests: 191)

Forum statistics

Threads
30,540
Messages
266,126
Members
14,667
Latest member
TacoCat

Latest posts

Top