Lost A Front Wheel Bearing........!!!

[Tbar]

-mad -mad I have a wheel bearing that is toast!!! -mad -mad

Its loose as a goose...........do I dare drive it to work tomorrow and pick up a bearing on the way home or drive the wifes "mom mobile"???

Also, who has a link on the R & R. The one I had book marked is no longer any good.

Looks like my weekend is planed.


Tbar

 

[whatabudro]

hmm that sucks drive the wifes.

 

[dboyw]

Tbar, is the link you had from TDS? If so you can still find it.

http://www.thedieselstop.com/archives/indextranslate.html

Use above link in one page, open link you have in another. Look for the 7 digit number at the end of the stuff in the address bar. Plug it in the link about and you should be good to go. Worked on all my bookmarks, except two.

If this does not help you, then I'm out.

 

[Tbar]

Tbar, is the link you had from TDS? If so you can still find it.

http://www.thedieselstop.com/archives/indextranslate.html

Use above link in one page, open link you have in another. Look for the 7 digit number at the end of the stuff in the address bar. Plug it in the link about and you should be good to go. Worked on all my bookmarks, except two.

If this does not help you, then I'm out.

Sorry, Thread ID was not found!


Tbar

 

[whatabudro]

You could always try a search over there

 

[Tbar]

You could always try a search over there

I hate there search mod over there........... -mad

Been looking for 30 minutes now with no luck.


Tbar

 

[Frankenstien]

OK... with out instructions its fairly straight forward...once the Brake caliper is off, four nuts off the studs from the rear of the bearing unit, remove the snap ring that holds the hub assembly on, I recomend you get 4 new studs for the Bearing, or you'll have to be a ilttle creative in removing the old ones...I used a pipe wrench... and a large Vise... assembly is just reverse... remember how the dust plate went on... I put mine on backwards... had to un-do what I did.... to get it correct...

 

[silverado3500]

Easiest way I've found to remove the studs is to use a vice, and double nut them.

 

[Tbar]

I tried removing the studs.........they were tighter than dicks hat band.

Beat the crap out of a box end wrench trying to break them loose.


Tbar

 

[Elk]

If you have or can easily get it, try some PB Blaster. It works much better than WD40.