corian countertops

[BIG JOE]

Masking tape over where you want the hole, wear safety goggles,[drill a pilot hole], then a good sharp hole saw.. let the hole saw do the work.. Done deal.

 

[powerboatr]

thanks guys
bama thanks for the safety tip

its only 1.5 " hole so i will go slow and let the drill do the work


i got more honey do's right now than I can get done

 

[Scooter]

You can use a hole saw. Make sure it is very sharp. It is highly recommended that you apply tape over the surface to be cut to avoid chipping. You can also get a solid surface blade for a jigsaw but it sounds like a pretty small diameter hole. Drill speed should be moderate. You want to keep the heet down. Let the drill do the work.

I guess that means that the plasma cutter is out???

 

[95_stroker]

i got more honey do's right now than I can get done

I bet you didnt know that thing was a fixer-upper did ya.

 

[Yooper75]

i got more honey do's right now than I can get done

You think that one is bad? My dad just remodeled his 40' 93 Wanderlodge that thing was a real PITA.

 

[BIG JOE]

Owning an RV is EXACTLY like owning a PSD..... The Mods, Improvements and "Better Ideas", Never Stop.

 

[Tail_Gunner]

i got more honey do's right now than I can get done

So did that "honey do" list get longer or shorter with the new rig??

 

[Yooper75]

Owning an RV is EXACTLY like owning a PSD..... The Mods, Improvements and "Better Ideas", Never Stop.

You forgot more expensive too.

 

[BIG JOE]

You forgot more expensive too.

 

[powerboatr]

success
drilled two holes, nice and slow let the chipps curl and in about ten minutes we were through

thanks guys


tg...the list just gets longer at every turn,
at diner tonight we took measurement to have some cabinets made for the dining area

i got to do something about that UGLY tailpipe