Where to buy a size "R" (0.332" or 21/64) drill bit................

[BamaSixGun]

...........so I can drill the air intake manifold for the boost gauge installation?

 

[BamaSixGun]

Duh, called O'Reilly's and they have one for 5.99.

 

[trackspeeder]

That was easy.

 

[BamaSixGun]

Now come to AL and drill-tap this hole for me Track.

 

[trackspeeder]

Now come to AL and drill-tap this hole for me Track.

Bring it to West Virgina next week. You might have to follow the tracks from the yard goat to find me.

 

[BamaSixGun]

Well I got it drill, it wasn't pretty trying to drill a round hole on the round exterior of a Banks
Air Intake Elbow.

I got the hole tapped and the elbow fitting installed. I just hope it stays sealed up and no boost leaks.

 

[NevrKnow]

Damm, i woulda mailed you mine for free. Figure I'll never use it again. ( I hope)

 

[trackspeeder]

Well I got it drill, it wasn't pretty trying to drill a round hole on the round exterior of a Banks
Air Intake Elbow.

I got the hole tapped and the elbow fitting installed. I just hope it stays sealed up and no boost leaks.

Sounds like you had to chase the drill around a little.

 

[BamaSixGun]

I used my small drill press and tried my best to hold the round intake with one hand, while pulling down on the press with the other. The hole was going straight until the very end.

The bit kinda danced off in the other direction and made an oblong hole.

I ran the tap in alittle deeper so that it would put threads in as many places as possible.

It worked out in the end. Those Banks air intakes are not cheap.