Seat back removal?

[Mike Starr]

Hey Everybody,
Just found your site! Can you tell me how to remove the cover on the back of my front seat. Truck is 2002 F250 4WD offroad PSD. It has a fold down armrest and two independent seats on each side. I guess I turned the lumbar knob to much 'cause it just spins now. I was able to free the two sides but the top and bottom are still fastened. Thanks for any help. Mikey

Well I couln't wait haha...if you pull the bottom of the panel out after freeing the sides...and the plastic ribbed rivit thing comes out then slide the upper tabs free. Oh it was a broken spring...a thick one. Peace

 

[oi8228oi]

welcome.... glad to see ya got it on your own...

 

[WD40]

Hello Mike and welcome to SSD.com. Don't be a stranger.
We would like to know where you are from and all about your ride.

 

[powerboatr]

howdy mike
the seat should hava zipper at the very bottom in the crease area where it folds forward the arm rest have zippers to on the lower edges to teh rear.
also there may be a few VERY sharp edges on the seat bottom and back area be careful the metal there is stamped and covered with no mind to HANDS. and some have small clips along the corners near the zipper, as for the sides and the front of the seat pan there are long plastic clip type things that slip over a metal catch edge.

inside the arm rest is a big torx nut to remove it then the whole cover will gently slide up and off,
going back on roll it up and put it back on like a sock on a wet foot, start at the top and roll it back down snugging it as you go

oh and vist often
glad you found us

 

[DaveBen]

Welcome Mike. Glad you stumbled on to SDD.

Dave

 

[bushpilot]

Hola ! WELCOME ! Feel free to post some photos & fill out your profile...