MrTailLight
Full Access Member
Crumm, i like that pod set up you have there. where did ya get it? i might stick with that over the dash mounted!
Interest in a Full Trim Replacement Pillar Pod?
- Thread starter PSDfreak
- Start date
Crumm
Fordoholic
Information in your mount thread. It is a dash mounted pod.MrTailLight said:
hheynow
Señor Aceite de Soja
PSDfreak said:
FYI, dumb plastic "Pine Tree" deals are commonly know as push pins.
My pod came with the same push pins. While installing they were misplaced so Antonio and I decided to use the screw holes on the stock cover. I just drilled those two holes in my pod and ran the screws through both. It works just fine and you dont notice anything different looking.
rickh
Biodiesel Rules!
A peice that large would be cheap to pop out of ABS, maybe around 2 bucks each by the 1,000. The problem is... THE MOLD. In USA it would be 15k-20k. Overseas maybe 5-6k.
Just the tool steel to make a mold from for my column mount was 3,500, then all the lay out and machine work... 22k in US. Never priced overseas, just dropped it.
I would not buy a replacement insted of a cover. I think cover ups look fine.
If you got the time, you can hand lay one out of fiberglass.
Rick H...
Just the tool steel to make a mold from for my column mount was 3,500, then all the lay out and machine work... 22k in US. Never priced overseas, just dropped it.
I would not buy a replacement insted of a cover. I think cover ups look fine.
If you got the time, you can hand lay one out of fiberglass.
Rick H...
