Getting Dahl 100

[roosterdiesel]

Well I'm ordering a heated Dahl 100 today.


I'm getting the vacuum gauge and a spare filter. Should I run a 2 micron or 10 micron? Gonna pass on the install kit since I have a good source for that stuff.


BTW, my fuel pump is on it's last 2 legs I think. It can drop 15psi now at WOT in extreme. I think that's the next purchase before the Stealth.

 

[CHPMustang]

(When) I get to ordering the Dahl myself I'll stick with the 10 micron(after discussing it with Bob) for any less could put additional strain on the fuel pump if running alternative fuels JMO.

 

[roosterdiesel]

Hmmm, I may run bio in the future. Guess I'll discuss this with Bob when ordering. Thanks Bill!

 

[roosterdiesel]

Ordered!

Well I just clicked that button we like to click>>>>ORDER NOW


I called Bob to make sure the 100 was enough for my future upgrades. He was at lunch and still took the time to talk to me. It's in stock and will ship today!



Man I'm PMS'n!

 

[CHPMustang]

There's no way anything is gonna get by you now

Break out the camera when you go to install it too.

 

[roosterdiesel]

Just Arrived

Well the little brown truck just left.

Did anyone know you get a bracket when you order from Bob? Got a switch for the heater too. Gotta round up hose and fittings tomorrow. Who knows when I'll get to the install, I need a babysitter this weekend.


Gotta go change tranny fluid before it gets too dark!

 

[CHPMustang]

A so so bracket comes with the kit but you have to fab up a big heavy bracket that mounts to the frame to bolt up the Dahl bracket to

I think you'll be clear of the line of spring weather moving north oh wait it's winter!

 

[roosterdiesel]

I noticed I'll have to come up with something when I was doing the tranny fluid. Man I don't think I would have room for the 150!

 

[Fire1]

You can check out my solution http://community.webshots.com/album/117243477YNiGKo
It is just Aluminum 2" angle. I had to drill two hole in the upper frame flange, but it gets it up high since mine is a 2WD.

 

[WD40]

I guess I am just an old fart but I have never liked drilling holes in the upper or lower part of a truck frame. Just don't seam right to me when you have 6 to 8 in of flat steel to drill into.
Just my 2 Cents.