big bear
Full Access Member
anybody out there know how to do this mod., let me know and what parts i need. thanks! i've learned more since i joined this forum than from talking with all my friends, wished i had join sooner.



When I click on the "How to shim the FPR" link, there are no pictures? I am intersted in doing this mod, but would like visual back up. Anybody know where pictures can be obtained?
Thanks
clearer...thanks!
Well i decided to take a stab at this tonight...no such luck. i got the gauge installed and im surprised to report im sitting at approx 63 psi as is. Does this seem normal?
On to my problem though. I took off the part that is held on the the 2 torx screws, so far so good. Once I had it off, it took me a while to figure out what the brass sleeve was...the thing looked plastic until i took it out and hit on some metal. This is the brass sleeve right?
Finally, you are supposed to use #4 washers right?? I got 3 #4 stainless washers and those things are too big to fit INSIDE that brass sleeve. They are supposed to go INSIDE the brass sleeve correct? Is the spring supposed to fit through the center of the brass sleeve still? I dont see how that could increase the tension on the spring if it fits right through the washers.
Could someone please help me clear this up?