Question What did you do to your truck today?

DaveBen

SDD Senior Member
Joined
May 31, 2005
Messages
9,627
Reaction score
81
Location
Ukiah, California
Battery acid reacts with aluminum and makes the white snow looking stuff. Just brush it off and rinse with water and baking soda (and NOT baking powder).

Dave
 

NevrKnow

Full Access Member
Joined
Mar 23, 2009
Messages
401
Reaction score
0
Location
Aiken,SC
Will do Dave. Thanks. Im assuming when my batteries went bad some acid got blown around? There was some in the bottom of both trays. if that's all it is then no biggy. WHEWWWW! I had never seen that before and was getting a little anxious.
 

hheynow

Señor Aceite de Soja
Joined
Apr 1, 2005
Messages
2,194
Reaction score
0
Location
Northern California
Decided it was iffy using B99 so late in the fall so I broke down and actually bought some diesel blending it down to B50.
 

BamaSixGun

SDD Super Mod/Staff
Joined
May 19, 2006
Messages
7,050
Reaction score
4
Location
Alabama The Beautiful
Installed 8 new glow plugs by DieselRx, sold by Pensaloca Fuel Injection.

It took about 4 hours to do. The hardest part was removing and reinstalling the fender liners. -mad The glow plugs themselves were quite easy, with the exception of a few of the glow plug harness connections.

My shoulders are worn out from doing this. OH, I found out that it also helps if you check your fluid levels in your batteries. That was probably more of my problems with start ups in the colder mornings. It seems the pass. side had NO FLUIDS whatsoever. Made me feel like an idiot. Filled it up with acid and a little bit of water, should be OK for now.
 

sagebel

Stock? Pfft!
Joined
Apr 2, 2005
Messages
996
Reaction score
0
Location
Albuquerque, NM
Finally got rid of the straight pipe exiying in front of the tire and install a new 5" MBRP exhaust with 6" tip.
 

IHC Power

STOCK STROKE
Joined
Jul 17, 2009
Messages
281
Reaction score
0
Location
Walpole Mass
Missed this thread big time

In the past months the following has been accomplished. The turbo back 4" to 5" aussie stacks, back racks on, tool box and cb antennas installed along with cb, recon tail, third and clearance lights done, 2004 headlights and markers, 35" cooper discover stt's all plus the new spare rim to match. Double din pioneer nav,cd,dvd, bluetooth you name it. 2005 mirrors heated with led turn and marker lights. Halogen reverse lights and way more led's to come, just wired the trailer cord to relay box and junction box.signal wires ran just need more nice weather....
 

Zookie400

I WANNA GO FAST
Joined
Mar 18, 2007
Messages
1,683
Reaction score
0
Location
wallingford, CT
Finally got rid of the straight pipe exiying in front of the tire and install a new 5" MBRP exhaust with 6" tip.
isnt it so much nicer?!
In the past months the following has been accomplished. The turbo back 4" to 5" aussie stacks, back racks on, tool box and cb antennas installed along with cb, recon tail, third and clearance lights done, 2004 headlights and markers, 35" cooper discover stt's all plus the new spare rim to match. Double din pioneer nav,cd,dvd, bluetooth you name it. 2005 mirrors heated with led turn and marker lights. Halogen reverse lights and way more led's to come, just wired the trailer cord to relay box and junction box.signal wires ran just need more nice weather....
you have worked enough on your truck, come do mine now!
 

hheynow

Señor Aceite de Soja
Joined
Apr 1, 2005
Messages
2,194
Reaction score
0
Location
Northern California
Wasn't planning on doing anything special to her today until I...

Noticed a strong (bio)diesel fuel smell in the cab while driving so I figured I had a fuel leak. Made one stop on my way home and a HUGE puddle of fuel dropped from the valley hole on to the pavement. Got home fine but as I was shutting off the truck I noticed a huge cloud of white smoke from under the bed. :eek: Now that's a first! :D Turns out the leak was gushing from the fuel bowl drain where the two torx screws hold the two o-rings flush with the fuel bowl. It had filled under the fuel bowl, filled the valley wetter than I've ever seen. It gets better. So I'm driving and all this fuel is dripping down the valley hole covering my tranny, tranny bracket, drive shaft...which spun it over everything rearward (rear axle, diff, brake lines, shocks etc.) plus my rear tank skid plate is totally wet. Then my hot exhaust got splattered with fuel which was the white smoke cloud. :D So I pulled the fuel bowl out just before darkness. I replaced the two 202 o-rings with Viton and will put everything back tomorrow.

That's what I did today. :bp
 
Last edited:

02stroker

Full Access Member
Joined
Feb 14, 2008
Messages
318
Reaction score
0
Location
Gratz, Pennsylvania
Just finished installing Energy Suspension polyurethane bushings in the front sway bar, track bar, front leaf springs, and rear leaf springs. No more bumps, rattles, or clunks. I think the track bar was the major problem. Had a mark on the frame on the passengers side where the tire would touch every once in a while during a right hand turn. Had to use a ratchet strap to pull the body of the truck toward the left side of the axle 1/2" to get the upper bolt in the track bar. Sway bar end links were shot to. And it looks like the sleeves in the front leaf spring bushings were sliding inside the rubber. Just alot of wear all the way around I guess. Thank God for a shop press and a 2 post lift. I would not want to do this job without them.
 

Zookie400

I WANNA GO FAST
Joined
Mar 18, 2007
Messages
1,683
Reaction score
0
Location
wallingford, CT
Wasn't planning on doing anything special to her today until I...

Noticed a strong (bio)diesel fuel smell in the cab while driving so I figured I had a fuel leak. . . . . . . . . . So I pulled the fuel bowl out just before darkness. I replaced the two 202 o-rings with Viton and will put everything back tomorrow.

That's what I did today. :bp


thats not fun.
 

Members online

No members online now.

Forum statistics

Threads
30,540
Messages
266,126
Members
14,667
Latest member
TacoCat
Top