Oil and Fuel pressures

[Digital Oxygen]

Where are you guys tapping Oil and Fuel pressure senders for aftermarket gauges?

Thanks a bunch

 

[CSIPSD]

What truck? SD or OBS? On a SD there is a port next to the oil filter, and another one on top of the HPOP. For fuel there is a port on the drivers side rear of the filter ass.

Also added the Tranny port and the water temp port... The Fuel pressure is a bad shot but it gets you in the right place...

 

[Digital Oxygen]

Sorry...

03 6.0 liter. I have the water tapped into the engine block, and the tranny tapped in the location you have.

 

[nascar_fan28]

i bought an oilgaurd oil filter cap, then just hooked oil sender up to it.. works great doesnt look bad

 

[Digital Oxygen]

Hey, that's a good idea. I'll call them tomorrow. thanks a bunch.

 

[Digital Oxygen]

Well hell. Oilguard won't sell me just the cap. Do you guys have any other suggestions for where I could go for one?

Thanks a bunch.

 

[FTG-05]

Well hell. Oilguard won't sell me just the cap. Do you guys have any other suggestions for where I could go for one?

Thanks a bunch.

Why not? I bought the Oilguard oil filter cap and the oil filler cap for my Amsoil BK-13 bypass filter system.

Did you call or try over the internet?

 

[nascar_fan28]

i think i just called them.. they just sold me flilter cap.. lil expensive think 90 bucks

 

[Bolt]

You need the fittings like this picture, that way you can tap into the factory oil pressure sending location.

That starts with a Male #4 to 1/4 SAE female swivel.

Then a 1/4 nipple and T.

On the side of T put a 1/4 NPT male by #4 Female O ring seat the thread your factory sender into.

Then screw your aftermarket oil pressure sender into the top of the T, and you are all set.