Ok, I am at my wits end here. My Beast was doin great till the guys at the detail/service center messed with my aftermarket performance computer. It's been 2 weeks now and I still can't drive more than a few miles without him shuttin down on me. Had to get towed again today...
Today's episode was a hesitation, followed by the check engine light, then dead...I got him started long enuf to pull into a parking lot.
This is what's been done so far to try and rectify the problem:
removed the fried up remote start and alarm system..."nice" detail boys soaked all the components under the steering column, that, along with the "helpful" service tech screwin with my computer lead to the following corrective actions:
Powertrain Control Module - reprogram
Camshaft Position Sensor - replace
Powertrain Control Module Power Relay - Replace ECM Relay (B)
PCM Connctor - replace
Any ideas or suggestions? Dang it, all I was tryin to do is get my Beast spruced up and get an oil change!!
Gina
Today's episode was a hesitation, followed by the check engine light, then dead...I got him started long enuf to pull into a parking lot.
This is what's been done so far to try and rectify the problem:
removed the fried up remote start and alarm system..."nice" detail boys soaked all the components under the steering column, that, along with the "helpful" service tech screwin with my computer lead to the following corrective actions:
Powertrain Control Module - reprogram
Camshaft Position Sensor - replace
Powertrain Control Module Power Relay - Replace ECM Relay (B)
PCM Connctor - replace
Any ideas or suggestions? Dang it, all I was tryin to do is get my Beast spruced up and get an oil change!!
Gina