have a 01 7.3 ordered a tw 3 position chip from him put it on the truck as directions said went to start up the truck for the first time and it didnt want to start so i tried a second time and it fired up took it for a drive seemed to work just okay... maybe a little bit of a gain over my evolution programmmer if any so i drove it home shut it off and i was never able to het it to fire back up at all it just cranks. called up tony and talked with him about it. the traces on my pcm were worn down to the copper(silver is suppose to show) hopeing this was the problem with a bad connection, i had the traces saudered like he said to do, put it back in the truck and it just cranks and cranks....when i take the chip out the truck starts just fine so i know the pcm is good. i am now sending it back to him he will either reburn it or send me another one...
my big question is is why did it start and run then when i just shut the truck off for a second it never restarted again even after the traces were saudered? any thoughts? i even disconnected the battery before installation with the keyes out, should i just leave the keys out with the battery connected? just never really heard of a chip burning itself up like that or breaking...
my big question is is why did it start and run then when i just shut the truck off for a second it never restarted again even after the traces were saudered? any thoughts? i even disconnected the battery before installation with the keyes out, should i just leave the keys out with the battery connected? just never really heard of a chip burning itself up like that or breaking...
Last edited: