the_hammer
Full Access Member
Does anyone have any tips on how to remove the FX4 stickers from my box? I would like to take them off, but am not sure what would be a same method of removing the glue.
FX4 Stickers
- Thread starter the_hammer
- Start date
powerboatr
living well in Texas
i removed my 4x4 decals mine from my 250 a few years back. i gently peeled one edge and then applied liberal amounts of sopy water as i peeled them off.
after they are off wash the area real good then wax it.
speed kills take your time and go slow and steady they should peel right off
after they are off wash the area real good then wax it.
speed kills take your time and go slow and steady they should peel right off
Wingdog
Full Access Member
A heat gun should work but don't heat it up too much or you'll burn the paint. A little heat and those things will roll right off.
BamaSixGun
SDD Super Mod/Staff
i like to use a 2" wide chisel, and a 5lbs. sledge hammer.
start tappin at one end to get it started, and it should peel right off.
then use liberal amounts of touch up paint from K-mart to cover up the scratches.
, i couldn't help myself.
i personally like my FX4 stickers, gives a little touch of color.
but what the others above said should work just fine.
start tappin at one end to get it started, and it should peel right off.
then use liberal amounts of touch up paint from K-mart to cover up the scratches.
, i couldn't help myself.i personally like my FX4 stickers, gives a little touch of color.
but what the others above said should work just fine.
atk
Moderator
A heat gun should work but don't heat it up too much or you'll burn the paint. A little heat and those things will roll right off.
ditto...have used this method alot of times with no problem....
05 Super Duty
SDD Junior Member
A hair dryer works well to help loosen up the adhesive...took mine off tonight.
BamaSixGun
SDD Super Mod/Staff
its something that has crossed my mind.
got any before and after pics?
got any before and after pics?
police stroker
Full Access Member
Go by a body shop and they can use a eraser wheel to remove them. It's just a large rubber wheel that peels it off with no damage to the paint.
fordtrucker4life!
I work with waste
I have one. Snap-on crud thug. Works great
and I couldn't believe that it didn't harm the paint after how violent the wheel spins. 
94f450sd
certified nutjob
amonia.get a corner lifted a little and spray straight amonia on it and wait a few minutes and start peeling and spraying.
