Help Needed AXLE Problems!!!!! Help PLZ

[BigSilverHD]

Yeah I finally figured that out but I decided to call the dealership and for 10.00 bucks I decided to save some elbow grease and bought the new ones haha now I. Just got to figure out how to put them in LOL....any suggestions?

 

[Dieselpwrdredneck]

i've always used the nuts and just double nutted them to turn them in, make sure to use lock-tite

 

[BigSilverHD]

Well the job is completed and thatnk you everybody for your help

 

[bigblack250]

worry more about if the joint behind there is loose..
you're getting that up/down because the vacuum seal is like a Wear-Ever seal on a bulldozer, rather than a solid disc..

so the seal in there is for vacum? is there like a bushing that the short shaft rides in?

 

[rwlundberg]

where the ball joints all that hard?? thinking about replacing mine in a month or two.

 

[BigSilverHD]

Well I'm not sure about the ball joints, but the wheel bearings were easy. Is that what you were refering to?

 

[fordfury]

the ball joints are not hard, just having the right tool for the job get expensive.