Autometer 7075 pillar kit install

[travis.bell2007]

I am very close to buying the pillar kit from autometer. I am looking at the installation of the pyrometer and checked my drivers side manifold to see accessibility and what not. I have a probe in my manifold already but no gauge any ideas or am I just a dumbass and didnt know I had a gauge.

Sent from my SM-G900T using Tapatalk

 

[01yellerCobra]

Can you trace where the probe goes?

 

[travis.bell2007]

It goes up to a bracket and then turns into an electrical clip

Sent from my SM-G900T using Tapatalk

 

[travis.bell2007]

The electric clip goes into a wiring loom and is gone

Sent from my SM-G900T using Tapatalk

 

[BIG JOE]

The probe is wired into the PCM/ECM. Not visual to you.. EGT data goes to the ECM/PCM to keep things within EPA parameters and protects you from overworking things too.

Joe

 

[travis.bell2007]

The probe is wired into the PCM/ECM. Not visual to you.. EGT data goes to the ECM/PCM to keep things within EPA parameters and protects you from overworking things too.

Joe

Thank you for the clarification. I'm leaning more towards the edge insight after alot of reviewing.

Sent from my SM-G900T using Tapatalk

 

[BIG JOE]

My Edge CTS gives 4 location options for monitoring EGTs. I like that. ALL from the Data Port.. under the dash. Plug'n Play.

Joe

 

[travis.bell2007]

Well I think you just sold me on it. Seems so much more versatile.

Sent from my SM-G900T using Tapatalk

 

[01yellerCobra]

Even the 6.0's are set up like that?

Misspelling brought to you by Tapatalk

 

[BIG JOE]

Well I think you just sold me on it. Seems so much more versatile.

Sent from my SM-G900T using Tapatalk

Even the 6.0's are set up like that?

Misspelling brought to you by Tapatalk

You guyz might wana check with EDGE... to be sure of the right CTS to get and if the EGTs are readable from the Data Port... depends on Year, Make, Model and Engine ?

Their Techs know their Stuff.

Joe