6.0 Tranny Cooler Upgrade on 7.3
- Thread starter Tbar
- Start date
aklim
Full Access Member
The cooler has 2 barbs going towards the ground and your hoses run parallel to the ground so it might be easier. Also, you need to reduce the hose size from 1/2 to 3/8
dpantazis
#12
here are pics of my install.
6.0 Trans Cooler pictures from trucks photos on webshots
i am not sure why you would need 90's. i used brass bar tube fittings in i think 3/8" NPT nut to butt.
photos should be self explanatory.
EDIT: the 90's might clean up the sweep of the tubing top make the route cleaner to the lines.
6.0 Trans Cooler pictures from trucks photos on webshots
i am not sure why you would need 90's. i used brass bar tube fittings in i think 3/8" NPT nut to butt.
photos should be self explanatory.
EDIT: the 90's might clean up the sweep of the tubing top make the route cleaner to the lines.
dpantazis
#12
bolted right in.
lines out the bottom of the cooler are 1/2". lines from the tranny are 3/8"". i used the two barbed hose fittings to adapt sizes. connections to the 3/8" hardlines are jstu hose clamps. there should be some notes under the photos. ez-peezey, chicken and pie.
lines out the bottom of the cooler are 1/2". lines from the tranny are 3/8"". i used the two barbed hose fittings to adapt sizes. connections to the 3/8" hardlines are jstu hose clamps. there should be some notes under the photos. ez-peezey, chicken and pie.
Deerjager
Meister Gewehr
Is the 6.0 cooler a better cooler? Wondering why do the upgrade. Thanks.
dpantazis
#12
its almost 3 times as big. look at the pics i linked.
Deerjager
Meister Gewehr
its almost 3 times as big. look at the pics i linked.
Makes sense, I did not catch the old one laying on the new when I looked at your pics. Looks like I might want to do the same thing. Thanks.
