Search results

  1. Frankenstien

    Electrical question

    Does it function from the door itself?.... or not... is the malfunction only from the Drivers door switch?... if neither , work, first guess would be a broken wire at the door. or possibly a bad connector on the window motor.
  2. Frankenstien

    9th Gen Superduty Windshield Size?

    The only difference that I'm aware of is where the "Black" paint is on the windshield, as sometimes it may hide the Vin Plate. May have them check that before install. a razor blade will remedy the issue.
  3. Frankenstien

    new to 7.3L with 6spd

    Being a 2wd you will have certain challenges when "modifying" Once you put some power to the gear box, you will find the stock clutch was never meant to handle real power.... then you'll upgrade the clutch and find you have a real hard time backing up, as the new clutch "GRABS" all to well...
  4. Frankenstien

    overhead console/lie-o-meter

    Dont have it, but I do remember that when you have it apart, the problem is usually very obvious, if your comfortable with a soldering iron and a heat sink you can repair your self in just a few min.
  5. Frankenstien

    Door Ajar Light???????

    Most cases No, Not sure if "Gem" codes show up on CAN II ODBII scans
  6. Frankenstien

    Door Ajar Light???????

    Good point, sorry I missed it, the next item to look at is the "Gem" Module. curios, have you had your windshield replaced lately?
  7. Frankenstien

    Door Ajar Light???????

    Easy way to find out which door, Once the light "TIMES" out, open a door, if the light comes on,... its not that door. By the light I mean the ceiling cab light. And yes The switch causes all of the symptoms you describe. Had the Same problem with our Navigator.
  8. Frankenstien

    Got some new winter tires on

    they look awfully small....... <<< :-D >>>
  9. Frankenstien

    High Oil pressure after oil change?

    The oil pressure sending unit on our trucks is pretty much an on/off you'll need a gauge to show for sure.
  10. Frankenstien

    Clutch goes to the floor

    Last one I had apart, 2 rubber o rings, a roll pin held the assembly in place.
  11. Frankenstien

    Laid Off. AGAIN!

    ...And Charleston SC. along with Lots of new construction.
  12. Frankenstien

    Clutch goes to the floor

    Possibly, but most likely your clutch fork collapsed. Been there done that. Pull the slave cyl out of the bell housing, be careful not to let the push rod fall out (if it hasn't already) flash light will tell you for sure.
  13. Frankenstien

    2000 7.3 rough running

    Food for thought, while the engine is cold... and I do mean cold, start it up run it for a few minutes, just long enough for the exhaust manifold to START to get warm. Shut her off. Manually touch each exhaust port, if you have a bad one you will FEEL the difference. Might give you a clue of...
  14. Frankenstien

    What the heck is this

    ... and I'm sure a few fellas might give you a dollar or two if n ya wanted to get rid of it.
  15. Frankenstien

    Got alot of Steering slop!

    and for the Adjustment, tho these are not our trucks they are close enough to get an idea as to how and what... Google Image Result for http://image.rodandcustommagazine.com/f/techarticles/9202902+w200/0607rc_09_z+steering_box+opening_steering_box.jpg
  16. Frankenstien

    Help Needed 99 7.3 rough idle / lack of initial acceleration

    Personal thought on this are your Valve cover gaskets... may want to pull and reconnect.
  17. Frankenstien

    RV Graphics going/gone bad ?

    Yes. Joe...... show us the results...
  18. Frankenstien

    Hi Sue Jean, Need to look close at the wire bundle as it travels down the frame rail from the...

    Hi Sue Jean, Need to look close at the wire bundle as it travels down the frame rail from the engine compartment back. Another way to check this would be to check each pin on the 7 pin connector to ground. if there is a short it will/should register there.
  19. Frankenstien

    Help Needed Weird Electrical Problem with our 2001 Ford F-250 SD

    I dont believe you will find your problem under your dash. Check the wiring from under the hood to the Trailer plug, if you have a chaf in the break or light wire this could feed 12v into any number of things. Also being in Al. check for Mud dobber nests in your 7 connector plug. Next ...
  20. Frankenstien

    Towing

    Have always pulled with the max HP setting, always around 8 worst/ 13 best mpg. As your rig is similar to mine, keep an eye on the EGT's Make sure your boots are snug, a long hill with 20 + lbs of boost will help them find there way off the pipes... I Have a LOT of miles on the truck... More...
  21. Frankenstien

    Front axle hub bearing and seal HELP

    I recall having this issue once upon a long time ago, If I recall, I removed one of the 2 thrust washers, drove the truck around for a week, the next weekend the washer fit in just as it should. not sure what was holding things up... but it did eventually all go back together.
  22. Frankenstien

    E-Brake adjusments?

    irace mine.... your there.... I found the best way to do this is throw a bottle jack under that wheel, turn the wheel, turn the star till you hear the pad start to rub, then do the other side.
  23. Frankenstien

    strange surprise under the hood

    Looked at the picture close.... It looks like you had a fire.... get enough oil... on a HOT day, and the temps are just rite on the inside with a bit of o2. I noticed the discoloration of the metal underneath the cap, has the genuine appearance of heat stress.
  24. Frankenstien

    strange surprise under the hood

    ...Lets just face it.... your engine is upset at you for not getting that BB turbo, and those new injectors.... just consider this a warning.... :-D
  25. Frankenstien

    6.7l

    Hi Scott.... So how many times have you found that you signal to change lanes but forget the signal is still going.... For those who dont know there is no longer a mechanical turn signal switch, its a digital switch, it cancels when you make a turn ... but there is no hold it while you...

Members online

Total: 398 (members: 1, guests: 397)

Forum statistics

Threads
30,547
Messages
266,142
Members
14,676
Latest member
FlorWhitfe

Latest posts

Top