Quadruple 2 5/8 Guage Dash Pod

[TERRCO]

Well I've been workin on this pod on & off for 6 months.I couldn't find a guage pod like what I imagined and after posting on it I got good advice from GarbageMechanic and STurbo90. I took GB advice of make it yourself and followed STurbos lead on his pod he made out of fiberglass.I am by no means a fiberglass expert but luckily my dad (who use to do alot of fiberglass work on cars and planes)caught me making a mess and guided me in the right direction.I am a carpenter by trade so I started with 2 pieces of 2x6 stacked together.After several passes thru the table saw I got my bevel on the back side.Alot of finish sanding and rounding and I had a mold.Following STurbos steps I covered the mold with maskintape and started layin on the glass.This is where my dad stepped in and got me going right.After about 3 coats I removed my pod from the mold.On and off I worked on it finishing slowly.I figure I have about 8 hours in it.My time is limited after work and on weekends so I still haven't reconnected the pyro's.The pressure guage is for my on board air which is also still in the works.About 90% complete.To see the pod click on GUAGEPOD in my sig.I appreciate all responces good or bad.

 

[kenholl]

I would say you did an outstanding job! I admire anyone who can use their creative ability to come up with a solution...

 

[platinum01]

That is a good lookin pod that you made. Keep up the good work.

 

[ckamp52]

hey man think that it turned out great. i also thought that i would b creative a time or 2 with fiberglass and it didnt turn out anywhere near that nice. it turned out in the scrap pile

 

[BamaSixGun]

I'm impressed, very good job.

 

[BIG JOE]

Nice, VERY Nice..... Super good workmanship there.. Terrco