Basic Mods for a 96 PSD

[Silver96PwrStrk]

I recently purchases 1996 4x4 5spd PSD w/3:55 gears. I dont want something that can run 11's in the 1/4 mile. I just want to increase the efficiency of the truck.

Mods im interested in:
Air Intake
Intercooler
Exhuast
Chip

 

[Tx_Atty]

Mods im interested in:
Air Intake --- Tymar open element (www.tymarperformance.com for phone #)
Intercooler
Exhuast --- 4" turbo back - up to you on cat and muffler
Chip

That is what I have done so far. You will want gauges before the chip so you can monitor the effects.

Welcome to the board.

 

[Silver96PwrStrk]

thanks for the input. so far my first experiances here are good. i have alot of turbo/gasoline experiance from my mustang days. some knowledge should be applicable

 

[95_stroker]

Gauges first, then start your modding. Youre alright doing the intake and exhaust without guages, but dont add power (chip, fuel system mods) without guages first.

CLICK HERE for a couple of pages of tips and ideas and DIY mods. There is some 99+ Super Duty info in there as well, so be sure you are reading for 94-97 OBS stuff.

 

[Silver96PwrStrk]

Ok i'm ordering:
2-pod pillar w/ Boost/Pyro gauges from autometer
3" DP with Cat-delete pipe
intake kit with k&n conical

will do a chip last when all those are installed

 

[dante59]

hi ,, i was just wondering about your choice of filters, k&n , tymar. iv'e read about both pros and cons . just your take on it.. thanks ,,dante59