Search results

  1. T

    Camshaft Timming???

    Camshaft Timing??? Has anyone ever had a problem with the gear on the camshaft moving? I have heard that the pulley is pressed on the shaft ( Dave at Swamps ) & it can loose it`s fit & start moving front to back , (floating -Jodey @ DP ). If you have had this problem what was the fix??? I...
  2. T

    here's a question

    You could do a contribution test & that will tell you if you have a weak cylinder & a buzz test. Not a lot of $$ for these two tests.
  3. T

    Question Why ?? is my truck running poor?

    I got the IDM out of the case - spotless . Sealed it back up & put it back in.I would like to know where the sensors are that tell the IDM to fire?? :dunno
  4. T

    Help Needed Idm ???

    I took it out of the case, saw nothing wrong with the board,sealed it back up & put it pack in the truck. Still have the same small miss.
  5. T

    Help Needed Idm ???

    How do you tell if the IDM is good or bad?? I have mine out & this truck has ben missing irradically Thanks T.T.
  6. T

    Question Why ?? is my truck running poor?

    I think I am going to take the inner fender out to see if the module has any damage, then I will replace the RH wireing & gasket. I kind of think it is the module because it is a random miss & it can miss two or three times in a row & it is getting worse.
  7. T

    Question Why ?? is my truck running poor?

    I have already changed the drivers side wireing & the gasket,nothing changed . I`m thinking it could be the module under the fender because it is a small miss & comes & goes with temp & humidity.This feels like the timing is off & or like you have bad spark plug wires. As soon as you get 10 lbs...
  8. T

    Question Why ?? is my truck running poor?

    I have a intermittent miss that is worse with a heavy dew. I have put in new injectors $$, new torque converter $$. This problem is at low rpm & little throttle about 2 to 5 psi boost. I think there is a module under the left fender that converts 12 volts to 140 volts dc could it be at fault...
  9. T

    slip joint

    I have the same problem & the lube on the splines looked fine ???:confused:
  10. T

    Help Needed Low boost miss

    Thanks Brandon I am going to start looking for parts.
  11. T

    Help Needed Low boost miss

    :rantI started the truck this morning ,died ,started ,died.... It was raining here this morning. I am starting to think electronicks, . Where is a good place to get the harness & valve cover gaskets from ?? Thanks ,T.Tolle
  12. T

    Help Needed Low boost miss

    There is 155 on the clock & I have yet to see white smoke??
  13. T

    Help Needed Low boost miss

    :dunnoI have a low (1 to 6 psi )boost miss. The fuel pressure is at 64- foot on the floor. Take the oil cap off & steady small stream of blow by.Miss gets worse with chip HP increase. Just put new injectors in to solve the problem. Can this be a computer problem - wiring or is this the $$...
  14. T

    Help Needed Injector trouble

    The new injectors are going to be put in next Tuesday. I sure hope my truck will run better.
  15. T

    Help Needed Injector trouble

    I run Stanodine , but I am about to put some 2 cycle oil in I think.
  16. T

    Help Needed Injector trouble

    The tank is 3/4 full & the pressure is at 68 psi.
  17. T

    Help Needed Injector trouble

    No I just felt the truck not running right , a little rough running. How about the 2 cycle oil fix , will that help my problem??
  18. T

    Help Needed Injector trouble

    HELP !! I have been having a rough running truck today & just heard a hard knock in the right bank. I think it is an injector. Is there something I can do other than replacing it?? I am planning on leaving on about 800 mile trip Sunday.Help & Thanks as usual to all.:hail
  19. T

    Question Hot water

    Thanks for all the comments , I was talking about the vaccume lines but I think I will order the valve that bushpilot had a link to . Thanks again :clap:
  20. T

    Question Hot water

    I rember reading about a valve that turns off the hot water so the vent air is cooler, anyone know where to find the write-up?:dunno
  21. T

    Door Ajar Light Problem?

    I had the same problem & the WD-40 solved it.:dunno:sweet
  22. T

    dead batteries

    Check your batterys one at a time. I had the same noise under the dash & I had 1 battery going bad, changed it & problem - gone. I know!!! I am going to replace the other battery soon.:sweet
  23. T

    DP tuner VS Six gun

    $0.50 Won`t get it , but for Drunken Parrot I want to wait until I get the DP installed to see what it does. Give me a call ( 270-590-4482). I am not at my phone a lot of the time but leave a message & I will get back with you ,Tony.
  24. T

    Hutch Mod?

    Thanks Tbar . I sure wish I had done that when I took the mixing valve out of the tank.
  25. T

    Hutch Mod?

    What is the harpoon mod?? :dunno

Members online

Total: 216 (members: 2, guests: 214)

Forum statistics

Threads
30,555
Messages
266,193
Members
14,679
Latest member
Jriltex

Latest posts

Top